If you know a lot about electronic gadgets and boards, you are aware of how tricky it is to find any reliable basic electronic starter kits on online sites. With the entire world currently facing lockdown and quarantine, going out to visiting any electronic mart is impossible.

Considering this, I am going to jot down some of the enticing and appealing features of Geekcreit. Geekcreit is one of the finest no battery version basic starter kits that works well with official (Arduino) boards.

Geekcreit Arduino Starter Kit Features:

• Upgrade version starter kit
• Stepper motor 1 x 5v
• 10 x blue, green, and red LED
• LM35 1x temperature sensor
• Infrared 1x receiver
• Cones up with 4 x keycap and switch
• Comes up with passive 1x buzzer and adjustable potentiometer
• 1x flame and 2x vibration sensor

Package included:

• 1 x compatible UNOR3 development board
• 1 x USB cable
• 1 x Prototype extension board
• 1 x Mini breadboard
• 1 x 5V stepper motor
• 1 x 2003 stepper motor driver board
• 10 x Red LED
• 10 x Green LED
• 10 x Blue LED
• 2 x Vibration Sensor
• 1 x Flame sensor
• 1 x LM35 temperature sensor
• 1 x Infrared receiver (no battery included)
• 3 x Photoresistor
• 4 x Keycap
• 4 x Key switch
• 1 x Adjustable potentiometer
• 1 x Passive buzzer (piezo buzzer)
• 1 x Active buzzer (tone generator)
• 1 x Jumper cap
• 1 x Large breadboard
• 1 x Remote Control
• 1 x 1602 Screen
• 1 x 9G servos
• 1 x Component box
• 1 x 10p DuPont line
• 30 x Breadboard line(approximately)
• 1 x 220ohm resistance
• 1 x 8*8 dot matrix
• 1 x One digit eight segment tube
• 1 x Four-digit eight segment tube
• 1 x IC 74HC595
• 1 x Battery Holder
• 1 x 1K resistor plug
• 1 x 10K resistor plug
• 1 x 2.54mm 40pin pin header